UNISONIC TECHNOLOGIES CO., LTD

UB2012

Preliminary

LINEAR INTEGRATED CIRCUIT

www.unisonic.com.tw

1 of 17

Copyright © 2010 Unisonic Technologies Co., Ltd

QW-R121-018.b

ADVANCED LINEAR CHARGE

MANAGEMENT IC FOR SINGLE

AND TWO-CELL LITHIUM-ION AND

LITHIUM-POLYMER

DESCRIPTION

UTC UB2012 is designed for portable electronics with lower cost. Its

advantages of high-accuracy voltage/current regulation, charging status

indication, temperature monitoring, and automatic charge-rate compensation.

In applications, the battery temperature is continuously under monitor

by using an external thermistor, if the temperature is over user-defined

threshold; UTC UB2012 inhibits charge for safety concern.

Generally, the UB2012 charges the battery in conditioning, constant voltage and constant current phases. If the

conditioning charge rate is around 10% of the regulation current and the heat dissipation in the external pass

element during the initial stage of the charge is minimized by the conditioning current. After the conditioning phase,

the UB2012 applies a constant current that be set by an external sense-resistor to the battery. The sense-resistor

can be on the battery without additional components. The constant current phase continues until the battery reaches

the charge-regulation voltage, then the constant voltage phase is beginning.

UTC UB2012 offers 4.1V, 4.2V, 8.4V and 8.4V fixed-voltage for single and dual cells. Charge stops when the

The automatic charge-rate compensation feature reduces the charging time of batteries. For the internal

impedance of battery pack during charge, this advanced technique offers safe and dynamic compensation.

FEATURES

* Ideal for Single 4.1V,4.2 V and Dual-Cell 8.2,8.4 V Li-Ion or Li-Pol Packs

* 0.3V Dropout Voltage for Minimizing Heat Dissipation

* Better than ±1% Accuracy of Voltage Regulation With Preset Voltages

* Dynamic Compensation of Battery Pack’s Internal Impedance to short Charging Time

* Optional Cell-Temperature Monitoring

* Integrated Voltage and Current Regulation With Programmable Charge-Current

* Integrated Cell Conditioning for Reviving Deeply Discharged Cells and Minimizing Heat Dissipation During Initial

Charge Stage

* Charge Status Output for Single or Dual Led or Host Processor Interface

* Automatic Battery-Recharge Feature

* Charge Termination by Minimum Current

* EVMs Available for Quick Evaluation

ORDERING INFORMATION

Ordering Number

Package

Packing

UB2012xG-S08-R

SOP-8

Tape Reel

Note: x: Output Voltage, refer to Marking Information.