962-5DA0-032 datasheet(4/12 Pages) MAGNETROL

4 / 12 page

Pump

Protection

Fill Line

Dual Point Alarm

High Alarm

Low Alarm

Spray Ball

A P P L I C A T I O N S

T Y P I C A L

Model 961 single point switches may be used for high or

low level alarm, as well as for pump protection. The Model

962 dual point unit is typically configured to measure

high/low, high/high, or low/low levels.

The

single

point

961

can

mounted

vertically

horizontally in vessels, bridles, or pipes. The dual gap 962

is always top mounted.

A broad selection of transducer materials allow the 961/962

to be used in a wide variety of process media. Metallic

transducers include 316 SS, Hastelloy® C, and Monel®. The

316 SS transducer has a NACE construction option for sour

gas service, and can also be built per ASME B31.1 and

B31.3 piping codes. Thermoplastic transducers include

Kynar® and CPVC. These corrosion resistant plastic trans-

ducers feature a stiffening tube that runs the length of the

transducer for extra rigidity. Kynar-faced 316 SS flange

options are offered with the Kynar transducers.

P U M P

C O N T R O L

A DIP switch on the Model 962 allows it to be configured

to control level, or to function as a pump controller. In the

pump control mode the unit can perform auto fill or auto

empty of tanks, sumps, or wet wells. The tip sensitive

lower gap allows liquid levels to be pumped down to

within

1⁄4" from the bottom of the vessel. The rigidity of the

flow through upper gap allows the 962 to be used even

when sumps experience severe turbulence from vessel

fill lines.

H Y G I E N I C

The hygienic version of the Model 961 features a deep

drawn stainless steel electronics housing. Tri-Clamp® and

DN65 Varivent hygienic process connections are offered for

use in food & beverage, pharmaceutical, and biotechnology

applications.

These

hygienic

transducers

have

3-A

(Authorization #596), EHEDG certification (per TNO Report

# V4772/01) and a 20 Ra finish to provide a uniform and

ultra-smooth

surface

that

inhibits

microbial

growth.

Electron beam welding technology is utilized to facilitate a

crevice-free surface inside the transducer tip. This allows

these transducers to be used in a wide variety of hygienic

applications where CIP (Clean-in-Place) is used to remove

any contamination from the transducer surface.

962-5DA0-032 数据表(PDF) 4 Page - Magnetrol International, Inc.

962-5DA0-032 数据表(HTML) 4 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

数据表下载