MIC29152WD datasheet(7/23 Pages) MICREL

7 / 23 page

Micrel, Inc.

MIC29150/29300/29500/29750

January 2012

M9999-013112-B

Notes:

Maximum positive supply voltage of 60V must be of limited duration (<100msec) and duty cycle (≤1%). The maximum continuous supply voltage is

26V. Exceeding the absolute maximum rating may damage the device.

The device is not guaranteed to function outside its operating rating.

Devices are ESD sensitive. Handling precautions recommended.

Specification for packaged product only.

Full load current (IFL) is defined as 1.5A for the MIC29150, 3A for the MIC29300, 5A for the MIC29500, and 7.5A for the MIC29750 families.

6. Dropout voltage is defined as the input-to-output differential when the output voltage drops to 99% of its normal value with VOUT + 1V applied to VIN.

VIN = VOUT (nominal) + 1V. For example, use VIN = 4.3V for a 3.3V regulator or use 6V for a 5V regulator. Employ pulse-testing procedures to pin

current.

Ground pin current is the regulator quiescent current. The total current drawn from the source is the sum of the load current plus the ground pin

current.

Output voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature range.

10. Thermal regulation is defined as the change in output voltage at a time T after a change in power dissipation is applied, excluding load or line

regulation effects. Specifications are for a200mA load pulse at VIN = 20V (a 4W pulse) for T = 10ms.

11. Comparator thresholds are expressed in terms of a voltage differential at the Adjust terminal below the nominal reference voltage measured at 6V

input. To express these thresholds in terms of output voltage change, multiply by the error amplifier gain = VOUT/VREF = (R1 + R2)/R2. For example,

at a programmed output voltage of 5V, the Error output is guaranteed to go low when the output drops by 95mV x 5V/1.240V = 384mV. Thresholds

remain constant as a percent of VOUT as VOUT is varied, with the dropout warning occurring at typically 5% below nominal, 7.7% guaranteed.

12. VEN ≤ 0.8V and VIN ≤ 26V, VOUT = 0.

13. When used in dual supply systems where the regulator load is returned to a negative supply, the output voltage must be diode clamped to ground.

MIC29152WD 数据表(PDF) 7 Page - Micrel Semiconductor

MIC29152WD 数据表(HTML) 7 Page - Micrel Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

数据表下载