| 数据搜索系统,热门电子元器件搜索 |
|
SP504MCF 数据表(PDF) 17 Page - Sipex Corporation |
|
|
|||||||||||||||||||||||||||||
SP504MCF 数据表(HTML) 17 Page - Sipex Corporation |
|
17 / 31 page ![]() 17 Rev: A Date:1/27/04 SP504 Multi–Mode Serial Transceivers © Copyright 2004 Sipex Corporation tory for more information). The drivers are controlled with the data bits labeled TDEC 3– TDEC 0. All of the drivers can be put into tri- state mode by writing 0000 to the driver decode switch. The three drivers TxD, ST and TxC, have a 150 Ω pull-down resistor to ground con- nected at the (b) output. This resistor is part of the V.35 driver circuitry and should be con- nected when in V.35 mode. Tri-state is possible for all drivers in RS-232 mode. The receivers are controlled with data bits RDEC 3–RDEC0; the code 0000 written to the receivers will place the outputs into tri-state mode. The 0000 de- coder word will override the enable control line for the one receiver (SCT). Using the V.35_STAT Pin The SP504 includes a V.35 status pin where the V35_STAT pin (pin 18) is a logic HIGH ("1") when the decoder is set to V.35 mode. The pin is a logic LOW ("0") when in all other modes including tri-state (decoder set at "0000"). Pin 18 allows the user to easily add FET switches or solid state relays to connect the external 150 Ω resistor for V.35 operation. V35_STAT can be connected to the gate of the FET switches or the control of the relays so that the 150 Ω resistors are connected to the non-inverting output of the three V.35 drivers. The output current of the V35_STAT pin is that of a typical TTL load of –3.2mA. The electrical specifications are simi- lar to the SP504 receiver outputs. This feature would reduce additional logic required by older traditional methods. NET1/NET2 Testing and Compliancy Many system designers are required to certify their system for use in the European public network. Electrical testing is performed in ad- herence to the NET (Norme Européenne de Télécommunication) which specifies the ITU Series V specifications. The SP504 adheres to all the required physical layer testing for NET1 and NET2. Consult factory for details. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |