Smart Card Interface

EMVCo approval of the interface module (IFM) contained in this Terminal shall mean only that the IFM has been tested in accordance and for sufficient

conformance with the EMV Specifications, Version 3.1.1, as of the date of testing. EMVCo approval is not in any way an endorsement or warranty regarding

the completeness of the approval process or the functionality, quality or performance of any particular product or service. EMVCo does not warrant any

products or services provided by third parties, including, but not limited to, the producer or provider of the IFM and EMVCo approval does not under any

circumstances include or imply any product warranties from EMVCo, including, without limitation, any implied warranties of merchantability, fitness for pur-

pose, or noninfringement, all of which are expressly disclaimed by EMVCo. All rights and remedies regarding products and services which have received

EMVCo approval shall be provided by the party providing such products or services, and not by EMVCo and EMVCo accepts no liability whatsoever in

connection therewith.

Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are

implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. The parametric values (min and max limits) shown in

the Electrical Characteristics table are guaranteed. Other parametric values quoted in this data sheet are provided for guidance.

Maxim Integrated Products Inc. 160 Rio Robles, San Jose, CA 95134 USA 1-408-601-1000 ________________ 15

© 2012 Maxim Integrated Products

Maxim is a registered trademark of Maxim Integrated Products, Inc.

Revision History

REVISION

NUMBER

REVISION

DATE

DESCRIPTION

PAGES

CHANGED

0

6/08

Initial release

—

1

8/08

2

2

2/12

Added the automotive TSSOP version to the Ordering Information and Selector Guide;

updated the Absolute Maximum Ratings

1, 2, 14

3

7/12

Added footnote to the resistor value on the PRES pin in Figure 8

13