●All specifications in this catalog and production status of products are subject to change without notice. Prior to the purchase, please contact NEC TOKIN for updated product data.

●Please request for a specification sheet for detailed product data prior to the purchase.

●Before using the product in this catalog, please read "Precautions" and other safety precautions listed in the printed version catalog.

2011.06.22 9307MPAVOL06E1106H2

Fixing Method:

⃝ Carefully prevent the piezo actuators from being bent, being twisted, or being applied tensile force.

Reference: Guide for tolerance of twisting and tension

Reference value

Remarks

Twisting force

3

For an actuator which generates a force of 800 N

（compression resistance）

Tension

50 N or less

⃝ Install the actuator so that the center axis of generated displacement is aligned with the center axis of the load.

a. Resin-coated type

• Epoxy-based adhesives are recommended for bonding. Select adhesives that have high rigidity and

allow minimum thickness so that the generation force and displacement cannot be deteriorated. Also do

not form adhesives at the side of actuator.

• When thermosetting resin is used, perform polarizing treatment

（see the caution section）again after the

adhesive is settled.

• The resin-coated type is weak to tensile force because of its structure and may be broken when tensile

force is applied onto the device. Using the device in the state that constantly applies compression is

effective against any mechanical damage. The pressure applied to this element should be kept at 20 to

50% of the force generated by this element

（compression resistance）.

• Install the element so that the axis of generated displacement is vertical to the mounting surface.

b. Metal sealed type

• Select the mounting bracket

（female thread type or flange type）according to the mounting method, and

install the element utilizing the bracket.

• Fix the element securely so that the generated force and displacement cannot be deteriorated.

• Connect the driven item at the displacement generating end after securing the mounting portion so that

it avoids unnecessary stress applied at the time of installation.

• Though this product is designed to apply a compressive force to the internal element by the metal case, avoid

any usages that cause bending, twisting, or tension force when the device is in use

Example of Actuator mounting

：

Guide to Use

Driving Method:

⃝ Connect the red lead wire to the positive（＋）terminal of the power supply. Also prevent reverse voltage application.

⃝ Basically the voltage controls the aimed displacement and generated force. In driving, however, it is also necessary

to take ringing due to the resonance or hysteresis of the element itself into consideration. In pulse driving, it is further

necessary to pay sufficient attention to heat generation due to dielectric loss, charge/discharge current due to the

capacitive component and the power output impedance as well. Please refer to the separately printed

literature,

“NEC TOKIN Multilayer Piezoelectric Actuators Userʼs Manual”

Spherical surface

Hinge

Piezo Actuator

Piezo Actuator

Moving part or load

Only one side is touching the actuator.

(Stress is concentrated on one edge

and generates share mode stress)

The actuator may break.

Piezo Actuator

Piezo Actuator

Piezo Actuator

Piezo Actuator

a) Example of wrong mounting

Imperfect alignment between actuator and load

<Actuator will be broken>

b) Example of correct mounting

Mount the device so that the load is uniformly

applied by the spherical surface or the hinge

Moving part or load

Multilayer Piezoelectric Actuators Vol.06 21