74ACT11521 datasheet(2/5 Pages) TI1

2 / 5 page

54ACT11521, 74ACT11521

8BIT IDENTITY COMPARATORS

SCAS023A − D2957, JULY 1978 − REVISED APRIL 1993

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

POST OFFICE BOX 1443

• HOUSTON, TEXAS 77001

2−2

logic symbol†

logic diagram (positive logic)

P = Q

COMP

P = Q

1P = Q

† This symbol is in accordance with ANSI/IEEE Std 91-1984

and IEC Publication 617-12.

Pin numbers shown are for the DW, J, and N packages.

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)‡

Supply voltage range, VCC

−0.5 V to 6 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

−0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, VO (see Note 1)

−0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0 or VI > VCC)

± 20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC)

± 50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC)

± 50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND

± 100 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range

−65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

‡ Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTE 1: The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

74ACT11521 数据表(PDF) 2 Page - Texas Instruments

74ACT11521 数据表(HTML) 2 Page - Texas Instruments

Html Pages

1 2 3 4 5

数据表下载