Si4010-RC-DEMO

2

Rev. 0.2

Figure 1. Si4010 Universal Key Fob Board and Plastic Case

(P/N 4010-KFOB-434 and MSC-PLPB_1)

Figure 2. Si4355 RFStick 434 MHz Receiver Board (P/N 4355-LED-434-SRX)

2. Operating the Demo

The Si4010 key fob transmitter and the Si4355 RFStick receiver are the transmitter and receiver devices used in

the one way link demo. This transmitter/receiver pair can be used to evaluate the capabilities of the Si4010

transmitter and the Si4355 receiver.

The first step is to insert the CR2032 battery in the battery holder on the 4010-KFOB-XXX demo board and then

place the board into the plastic key fob case. Next, insert the two AAA batteries in the battery holder on the 4355-

LED-XXX receiver board and turn it on by setting the S6 switch to the “Battery” position. LED4 will light

continuously indicating that power is on and the SRX firmware is running.

When a button is pressed on the key fob, LEDs flash on the receiver boad according to which button was pressed.

In the next table, buttons are named according to their position when the key fob is held with its LED facing

forward.

Table 2. Key Fob Buttons and Resulting LEDs

Key Fob Button Pressed

RF Stick LED Flashed

Left Button

LED1

Middle Button

LED2

Right Button

LED3

Rear Button

LED1 + LED3

Front Button

LED1 + LED2 + LED3