TOOLSTICK-BA datasheet(5/14 Pages) SILABS

5 / 14 page

Si4455-2Wa yLink-DEMO

Rev. 0.1

2.3.4. Custom Parameters

As it was stated above user can store custom RF parameters into the devices with WDS. One custom field is

available in each node. If any of the three RF parameters (frequency, modulation, data rate) is set to custom both

the other parameters are configured to be custom as well.

Notes:

The firmware drops an error message and continues with default parameters if no custom field is stored,

but custom parameter is selected.

The firmware goes to error state if the frequency band of the custom settings mismatches with the

frequency band of the device.

2.3.5. Default Demo Settings

The default demo settings are as follows:

Frequency band: defined by the HW

Frequency number:



Middle band: 1



High band—868 MHz: 2



High band—915 MHz: 4

Node address: 5

Modulation: High precision GFSK

Data rate number: 1 (FSK: 9.6 kbps, OOK: 2.4 kbps)

Toolstick-BA 数据表(PDF) 5 Page - Silicon Laboratories