Connect universal

9V supply

Three power LEDs

will illuminate

Connect USB port

to the PC

The computer may respond

with these messages

www.ti.com

Starter System Setup

Figure 20 shows the connection of the 9-V power supply to the USB DAQ Platform. When you connect

power, three LEDs on the USB DAQ Platform illuminate. If the LEDs do not illuminate, check the power

connections.

Figure 20. Universal 9-V Supply to USB DAQ Platform

Figure 21 shows the connection of the USB cable to the USB DAQ Platform. When you make this

connection, it is recommended that you first turn your computer sound on. When the cable is plugged in,

recognized. The USB DAQ Platform uses the HID drivers included in the Windows operating system. In

some cases, Windows may display messages the first time the EVM is plugged in (as shown here).

Figure 21. Connect USB Cable to USB DAQ Platform

21

SBOU087A

– August 2010 – Revised April 2011

Multi-Cal-System Evaluation Module

Submit Documentation Feedback

Copyright

© 2010–2011, Texas Instruments Incorporated