| 数据搜索系统,热门电子元器件搜索 |
|
AS8410 数据表(PDF) 16 Page - ams AG |
|
|
|||||||||||||||||||||||||||||
AS8410 数据表(HTML) 16 Page - ams AG |
|
16 / 19 page ![]() PWM DC Motor Regulator – Data Sheet AS8410 Rev. 1.0, December 2000 page 16 of 19 4.1.6 Oscillator, Reference Voltage / Current Generator The oscillator is used to control the PWM generator and the charge pump with a frequency of typical 18 kHz. The reference current Iref of this oscillator is generated by a temperature compensated voltage regulator which delivers a stable voltage of 1 V at pin OSC, the ROSC = 100 k Ω at this pin gen- erates the reference current. This reference current is used for other functions of this chip too (see section 3). Symbol Parameter min typ max Unit Note VOSC Reference voltage at pin OSC 0.96 1.00 1.04 V fOSC Oscillator frequency 17,0 18,0 19,0 kHz Trise/fall Rise or fall time of the clock 100 ns Iref Reference current 9,6 10,0 10,4 µA 1 1 I ref must be generated by the external resistor ROSC = 100 k Ω at the pin OSC 4.1.7 5V Regulator (bandgap reference) The 5V-regulator generates the supply voltage for all internal low voltage blocks and the rough reference voltage for the 1 V-regulator to generate the reference current Iref. This regulated 5 V supply can also be used externally (e.g. for the temperature sensor at pin TP). This externally usable 5 V will be switched off in the sleep mode. Symbol Parameter min typ max Unit Note Vbat Supply voltage of the regulator 6,5 12 35 V VDD Regulated voltage 4,7 5,0 5,3 V 1 IVDD_OUT External load current at pin VDD 3 mA 1 external capacitor to ground C VDD = 100 nF 4.1.8 Failures Detection, Failure Handling Procedures Three different kinds of failure detections and protections are implemented: 1. Failure detection of the load circuit (DC motor and power FET) 1.1 Over current detection and protection 1.2 No load detection of the motor and protection 1.3 Open wire detection (motor or power switch) 1.4 Short circuit of the power switch detection 1.5 Blocked motor detection and protection 1.6 Short-circuited motor segments detection and protection 1.7 Protection of the power FET and the ASIC, if the motor works in generator mode 2. Failure detection of the supply voltage Vbat (Over- / Under Voltage) 3. Over Temperature detection and protection in two modes |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |