REV. 0

AD8367

–4–

CAUTION

ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily

accumulate on the human body and test equipment and can discharge without detection. Although

the AD8367 features proprietary ESD protection circuitry, permanent damage may occur on

devices subjected to high-energy electrostatic discharges. Therefore, proper ESD precautions are

recommended to avoid performance degradation or loss of functionality.

WARNING!

ESD SENSITIVE DEVICE

ABSOLUTE MAXIMUM RATINGS

*

Supply Voltage VPSO, VPSI . . . . . . . . . . . . . . . . . . . . . 5.5 V

Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

±600 mV

Internal Power Dissipation . . . . . . . . . . . . . . . . . . . . 250 mW

Maximum Junction Temperature . . . . . . . . . . . . . . . . 125

°C

Operating Temperature Range . . . . . . . . . . . –40

°C to +85°C

Storage Temperature Range . . . . . . . . . . . . –65

°C to +150°C

Lead Temperature Range (Soldering 60 sec) . . . . . . . . 300

°C

*Stresses above those listed under Absolute Maximum Ratings may cause perma-

nent damage to the device. This is a stress rating only; functional operation of the

device at these or any other conditions above those indicated in the operational

section of this specification is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect device reliability.

ORDERING GUIDE

Model

Temperature Range

Package Description

Package Option

AD8367ARU

–40

°C to +85°C

Tube, 14-Lead

RU-14

AD8367ARU-REEL-7

–40

°C to +85°C

7" Tape and Reel

AD8367-EVAL

–40

°C to +85°C

Evaluation Board

AD8367ARU-REEL

–40

°C to +85°C

13" Tape and Reel

PIN CONFIGURATION

TOP VIEW

(Not to Scale)

14

13

12

11

10

9

8

1

2

3

4

5

6

7

ENBL

INPT

MODE

GAIN

DETO

ICOM

ICOM

HPFL

VPSI

VPSO

VOUT

DECL

OCOM

ICOM

AD8367

PIN FUNCTION DESCRIPTIONS

Pin

Mnemonic

Description

1, 7, 14 ICOM

Signal Common. Connect to low

impedance ground.

2

ENBL

A HI activates the device.

3

INPT

Signal Input. 200

Ω to ground.

4

MODE

Gain Direction Control. HI for Positive

Slope; LO for Negative Slope.

5

GAIN

Gain-Control Voltage Input

6

DETO

Detector Output. Provides output cur-

rent for RSSI function and AGC control.

8

OCOM

Power Common. Connect to low

impedance ground.

9

DECL

Decoupling Pin. Can Be Used to

Modify the Output Reference Level.

10

VOUT

Signal Output. Generally will be

ac-coupled.

11

VPSO

Positive Supply Voltage. 2.7 V to 5.5 V.

VPSI and VPSO are tied together inter-

nally with back-to-back PN junctions.

They should be tied together externally

and properly bypassed.

12

VPSI

Positive Supply Voltage. 2.7 V to 5.5 V.

13

HPFL

High-Pass Filter Connection. A capaci-

tor to ground sets the corner frequency

of the output offset control loop.