LCC110

www.ixysic.com

7

R06

Manufacturing Information

Moisture Sensitivity

All plastic encapsulated semiconductor packages are susceptible to moisture ingression. IXYS Integrated

Circuits Division classified all of its plastic encapsulated devices for moisture sensitivity according to

the latest version of the joint industry standard, IPC/JEDEC J-STD-020, in force at the time of product

evaluation. We test all of our products to the maximum conditions set forth in the standard, and guarantee proper

operation of our devices when handled according to the limitations and information in that standard as well as to any

limitations set forth in the information or standards referenced below.

Failure to adhere to the warnings or limitations as established by the listed specifications could result in reduced

product performance, reduction of operable life, and/or reduction of overall reliability.

This product carries a Moisture Sensitivity Level (MSL) rating as shown below, and should be handled according

to the requirements of the latest version of the joint industry standard IPC/JEDEC J-STD-033.

Device

Moisture Sensitivity Level (MSL) Rating

LCC110 / LCC110S / LCC110P

MSL 1

ESD Sensitivity

This product is ESD Sensitive, and should be handled according to the industry standard JESD-625.

Reflow Profile

This product has a maximum body temperature and time rating as shown below. All other guidelines of J-STD-020

must be observed.

Device

Maximum Temperature x Time

LCC110 / LCC110S

250ºC for 30 seconds

LCC110P

260ºC for 30 seconds

Board Wash

IXYS Integrated Circuits Division recommends the use of no-clean flux formulations. However, board washing to

remove flux residue is acceptable. Since IXYS Integrated Circuits Division employs the use of silicone coating as

an optical waveguide in many of its optically isolated products, the use of a short drying bake could be necessary

if a wash is used after solder reflow processes. Chlorine- or Fluorine-based solvents or fluxes should not be used.

Cleaning methods that employ ultrasonic energy should not be used.

Pb