| 数据搜索系统,热门电子元器件搜索 |
|
ACT4468DI 数据表(PDF) 1 Page - Aeroflex Circuit Technology |
|
|
|||||||||||||||||||||||||||||
ACT4468DI 数据表(HTML) 1 Page - Aeroflex Circuit Technology |
|
1 / 6 page ![]() CIRCUIT TECHNOLOGY www.aeroflex.com eroflex Circuit T echnology – Data Bus Modules For The Future © SCD4468D REV B 5/25/00 Features • World’s smallest and lowest standby power dual transceiver 0.3" x 1" packages • Dual transceiver meets military data bus requirements, MIL-STD-1553 and MIL-STD-1760 • Low power dissipation at full output power • Single +5V power supply • Current source output • Monolithic construction using dielectrically isolated(D.I.) • Processed and screened to MIL-STD-883 specs • DESC SMD# 5962–92061 Pending General Description The Aeroflex Circuit Technology Model ACT4468D is a next generation D.I. monolithic transceiver which provide full compliance with MIL-STD-1553/1760 and data bus requirements in the smallest packages with the lowest standby power consumption and one power supply operation. The dual channel Model ACT4468D perform the front-end analog function of inputting and outputting data through a transformer to a MIL-STD-1553/1760 data bus. Design of these transceivers reflects particular attention to active filter performance. This results in low bit and word error rate with superior waveform purity and minimal zero crossover distortion. Efficient transmitter electrical and thermal design provides low internal power dissipation and heat rise at high as well as low duty cycles. Each channel of the dual transceiver is completely separate from the other and fully independent. This includes power leads as well as signal lines. Hence, each channel may be connected to a different data bus with no interaction. Transmitter: The Transmitter section accepts bi-phase TTL data at the input and when coupled to the data bus with a 1:2.5 transformer, isolated on the data bus side with two 52.5 Ohm fault isolation resistors, and loaded by two 70 Ohm terminations plus additional receivers, the data bus signal produced is 7.5Volts nominal P-P at A-A’. (See Figure 5.) When both DATA and DATA inputs are held low or high, the transmitter output becomes Block Diagram (without Transformer), 1/2 of unit shown ACT4468D Dual Transceiver SHAPING OUTPUT STAGE COMP. COMP. REFERENCE ACTIVE FILTER INPUT AMP DRIVER TX DATA IN TX DATA IN TX INHIBIT +5 V STROBE TX/RX TX/RX RX DATA OUT RX DATA OUT GROUND ACT4468D Dual Transceivers for MIL-STD-1553 |
类似零件编号 - ACT4468DI |
|
类似说明 - ACT4468DI |
|
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |