VIPER Remote Control Systems

VIPER Remote Control Systems

VIPER Remote Control Systems

VIPER Remote Control Systems

DS VIPER-2

©2009 REG No 277 4001, Lewes, England. Page 4

Pairing a Transmitter to a Receiver

Pairing a Transmitter to a Receiver

Pairing a Transmitter to a Receiver

Pairing a Transmitter to a Receiver

Each transmitter has a unique identity. Each time a transmitter Switch is operated, it emits a secure

RF signal. The Receiver can learn this signal and allocate to any of its outputs.

The only limitation is that each receiver has a maximum memory for upto 40 pairings, these can be from

the same or any number of transmitters.

Hint: the same transmitter may be taught to different receivers to create ‘master keys’.

VIPER

VIPER

VIPER

VIPER----S1 / VIPER

S1 / VIPER

S1 / VIPER

S1 / VIPER----S2 / VIPER

S2 / VIPER

S2 / VIPER

S2 / VIPER----S3 (12

S3 (12

S3 (12

S3 (12----30Vdc Receivers)

30Vdc Receivers)

30Vdc Receivers)

30Vdc Receivers)

To Learn a New Transmitter switch follow this procedure

To Learn a New Transmitter switch follow this procedure

To Learn a New Transmitter switch follow this procedure

To Learn a New Transmitter switch follow this procedure

Any transmitter button can be learnt to one or many of the receiver output relays.

Each button must be learnt to each relay individually by following this procedure:

1.

Select the receiver output relay to learn to:

2.

Briefly press the receiver Learn switch (S2) once

3.

The Learn LED will flash once to indicate output relay 1 is selected

4.

After the LED stops flashing, press the Learn switch again to select the next relay channel

5.

Repeat step 2 until the required output relay is selected.

6.

Press the button on the transmitter you want to learn to the relay output.

7.

The Learn LED will then illuminate, press the same transmitter button again.

8.

The Learn LED will then flash to indicate learning is complete.

9.

The transmitter button will now operate the relay.

Erasing Receivers Memory

Erasing Receivers Memory

Erasing Receivers Memory

Erasing Receivers Memory

1.

Press and hold the receiver Learn Switch for approx 10 seconds.

2.

When the Learn LED turns OFF all memory is erased

NOTE:

NOTE:

NOTE:

NOTE: You cannot erase individual Tx encoders

Configuring Receiver Outputs

Configuring Receiver Outputs

Configuring Receiver Outputs

Configuring Receiver Outputs

The jumper links configure the outputs to be Momentary or Latching.

The jumper links are made / removed by the small link ‘cap’ placed over the pin header.

(The configuration shown in the picture above represents the third row of the table)

Link Positions

Link Positions

Link Positions

Link Positions

Relay Outputs

Relay Outputs

Relay Outputs

Relay Outputs

LK1

LK1

LK1

LK1

LK2

LK2

LK2

LK2

RLY 1

RLY 1

RLY 1

RLY 1

RLY 2

RLY 2

RLY 2

RLY 2

RLY 3

RLY 3

RLY 3

RLY 3

RLY 4

RLY 4

RLY 4

RLY 4

Closed

Closed

Mom

Mom

Mom

Mom

Closed

Open

Mom

Mom

Latch

Latch

Open

Closed

Mom

Latch

Latch

Latch

Open

Open

Latch

Latch

Latch

Latch