24LC024-IP datasheet(5/30 Pages) MICROCHIP

5 / 30 page

DS21210N-page 5

24AA024/24LC024/24AA025/24LC025

2.0

PIN DESCRIPTIONS

Pin Function Table

2.1

SDA Serial Data

SDA is a bidirectional pin used to transfer addresses

and data into and out of the device. It is an open-drain

terminal; therefore, the SDA bus requires a pull-up

resistor to VCC (typical 10 k

Ω for 100 kHz, 2 kΩ for

400 kHz).

For normal data transfer, SDA is allowed to change

only during SCL low. Changes during SCL high are

reserved for indicating the Start and Stop conditions.

2.2

SCL Serial Clock

The SCL input is used to synchronize the data transfer

from and to the device.

2.3

A0, A1, A2

The levels on the A0, A1 and A2 inputs are compared

with the corresponding bits in the slave address. The

chip is selected if the compare is true. For the SOT-23

package only, pin A2 is not connected.

Up to eight 24AA024/24LC024/24AA025/24LC025

devices (four for the SOT-23 package) may be con-

nected to the same bus by using different Chip Select

bit combinations. These inputs must be connected to

either VCC or VSS.

2.4

WP (24XX024 Only)

WP is the hardware write-protect pin. It must be tied to

VCC or VSS. If tied to Vcc, hardware write protection is

enabled. If WP is tied to Vss, the hardware write

protection is disabled. Note that the WP pin is available

only on the 24XX024. This pin is not internally

connected on the 24LC025.

2.5

Noise Protection

The 24AA024/24LC024/24AA025/24LC025 employs a

VCC threshold detector circuit which disables the

internal erase/write logic if the VCC is below 1.5V at

nominal conditions.

The SCL and SDA inputs have Schmitt Trigger and

filter circuits which suppress noise spikes to assure

proper device operation, even on a noisy bus.

3.0

FUNCTIONAL DESCRIPTION

The 24AA024/24LC024/24AA025/24LC025 supports

a bidirectional, 2-wire bus and data transmission

protocol. A device that sends data onto the bus is

defined as transmitter, while a device receiving data

is defined as receiver. The bus has to be controlled

by a master device that generates the Serial Clock

(SCL), controls the bus access and generates the

Start and Stop conditions, while the 24AA024/

24LC024/24AA025/24LC025 works as slave. Both

master and slave can operate as transmitter or

receiver, but the master device determines which

mode is activated.

Name

PDIP

SOIC

TSSOP

DFN/TDFN

MSOP

SOT-23

Description

Address Pin AO

Address Pin A1

—

Address Pin A2

VSS

Ground

SDA

Serial Address/Data I/O

SCL

Serial Clock

—

Write-Protect Input

VCC

+1.7 to 5.5V Power Supply

24LC024-IP 数据表(PDF) 5 Page - Microchip Technology

24LC024-IP 数据表(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

数据表下载