LAN8710AI datasheet(39/82 Pages) SMSC

39 / 82 page

Small Footprint MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR® Technology

Datasheet

SMSC LAN8710A/LAN8710Ai

Revision 1.4 (08-23-12)

DATASHEET

3.8

Miscellaneous Functions

3.8.1

LEDs

Two LED signals are provided as a convenient means to determine the transceiver's mode of

operation. All LED signals are either active high or active low as described in Section 3.8.1.2,

"nINTSEL and LED2 Polarity Selection" and Section 3.8.1.1, "REGOFF and LED1 Polarity Selection,"

on page 39.

The LED1 output is driven active whenever the device detects a valid link, and blinks when CRS is

active (high) indicating activity.

The LED2 output is driven active when the operating speed is 100Mbps. This LED will go inactive

when the operating speed is 10Mbps or during line isolation.

Note: When pulling the LED1 and LED2 pins high, they must be tied to VDD2A, NOT VDDIO.

3.8.1.1

REGOFF and LED1 Polarity Selection

The REGOFF configuration strap is shared with the LED1 pin. The LED1 output will automatically

change polarity based on the presence of an external pull-up resistor. If the LED1 pin is pulled high to

VDD2A by an external pull-up resistor to select a logical high for REGOFF, then the LED1 output will

be active low. If the LED1 pin is pulled low by the internal pull-down resistor to select a logical low for

REGOFF, the LED1 output will then be an active high output. Figure 3.7 details the LED1 polarity for

each REGOFF configuration.

Note: Refer to Section 3.7.4, "REGOFF: Internal +1.2V Regulator Configuration," on page 38 for

additional information on the REGOFF configuration strap.

3.8.1.2

nINTSEL and LED2 Polarity Selection

The nINTSEL configuration strap is shared with the LED2 pin. The LED2 output will automatically

change polarity based on the presence of an external pull-down resistor. If the LED2 pin is pulled high

to VDD2A to select a logical high for nINTSEL, then the LED2 output will be active low. If the LED2

Figure 3.7 LED1/REGOFF Polarity Configuration

LED1/REGOFF

~270 ohms

REGOFF = 0 (Regulator ON)

LED output = Active High

~270 ohms

VDD2A

REGOFF = 1 (Regulator OFF)

LED output = Active Low

LED1/REGOFF

10K

LAN8710AI 数据表(PDF) 39 Page - SMSC Corporation

LAN8710AI 数据表(HTML) 39 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

数据表下载