2

PS2012E

08/08/06

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012

PI74FCT245T

PI74FCT2245T(25 Ohm Series )

Octal BidirectionalTransceivers

Storage Temperature .................................................................... –65°Cto+150°C

Ambient Temperature with Power Applied .................................... –40°Cto+85°C

Supply Voltage to Ground Potential (Outputs & D/O Only) ........... –0.5Vto+7.0V

DC Input Voltage ............................................................................ –0.5Vto+7.0V

DC Output Current ...................................................................................... 120mA

Power Dissipation ..........................................................................................0.5W

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the device.

This is a stress rating only and functional operation

of the device at these or any other conditions above

those indicated in the operational sections of this

specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may

affect reliability.

Parameters Description

Units

Output HIGH Voltage

2.4

3.0

V

Output LOW Current

0.3

0.55

V

Output LOW Current

Ω Series)

0.3

0.50

V

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

V

Input LOW Voltage

Guaranteed Logic LOW Level

0.8

V

Input HIGH Current

1

μA

Input LOW Current

–1

μA

Input HIGH Current

1

μA

Input LOW Current

–1

μA

High Impedance

1

μA

Output Current

–1

μA

Clamp Diode Voltage

–0.7

–1.2

V

Power Down Disable

100

μA

Short Circuit Current

–60

–120

mA

Input Hysteresis

200

mV

Parameters

(1)

Description

Test Conditions

Typ.

Max.

Units

Input Capacitance

6

10

pF

Output Capacitance

8

12

pF

Notes:

1. These Parameters are determined by device characterization but are not production tested.

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

06-0207