PI3USB20L datasheet(2/6 Pages) PERICOM

2 / 6 page

PI3USB20

3.3V, Wide Bandwidth, 4-Channel,

2:1 Mux/DeMux USB 2.0 Switch

PS8697B

02/01/05

DC Electrical Characteristics for USB 2.0 Switching over Operating Range

(TA = –40°C to +85°C, VCC = 3.3V ±10%)

Paramenter

Description

Test

Conditions

Min.

Typ.(2) Max.

Units

VIH

Input HIGH Voltage

Guaranteed HIGH level

2.0

VIL

Input LOW Voltage

Guaranteed HIGH level

0.8

VIK

Clamp Diode Voltage

VCC = Max., IIN = –18mA

-0.7

-1.2

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±5

μA

IIL

Input LOW Current

VCC = Max., VIN = GND

±5

RON

Switch On-Resistance(3)

VCC = Min., 1.25V ≤ VIN ≤ VCC,

IIN = –40mA

Ω

RFLAT(ON)

On-Resistance Flatness(4)

VCC = Min., VIN @ 1.5V and VCC,

IIN = -40mA

1.0

ΔRON

On-Resistance match from center

ports to any other port(4)

VCC = Min., 1.5V ≤ VIN ≤ VCC,

IIN = -40mA

0.9

Storage Temperature ......................................... –65°C to +150°C

Supply Voltage to Ground Potential ....................–0.5V to +4.0V

DC Input Voltage .................................................–0.5V to +5.5V

DC Output Current ........................................................... 120mA

Power Dissipation ................................................................ 0.5W

Note: Stresses greater than those listed under MAXIMUM RAT-

INGS may cause permanent damage to the device. This is a stress

rating only and functional operation of the device at these or any other

conditions above those indicated in the operational sections of this

specification is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect reliability.

Maximum Ratings

(Above which useful life may be impaired. For user guidelines, not tested.)

Notes:

1. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.

3. Measured by the voltage drop between A and B pins at indicated current through the switch. On-Resistance is determined by the lower of the

voltages on the two (A & B) pins.

4. This parameter is determined by device characterization but is not production tested.

Capacitance (TA = 25°C, f = 1MHz)

Parameters(4)

Description

Test Conditions

Typ.

Max.

Units

CIN

Input Capacitance

VIN = 0V

2.0

3.0

COFF

Port I Capacitance, Switch OFF

4.0

6.0

CON

Switch Capacitance, Switch ON

6.0

10.0

PI3USB20L 数据表(PDF) 2 Page - Pericom Semiconductor Corporation

PI3USB20L 数据表(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6

数据表下载