M51995AP/AFP

REJ03D0835-0300 Rev.3.00 Jun 06, 2008

Page 36 of 40

2. MOS FET gate drive power dissipation

Figure 39 shows the relation between the applied gate voltage and the stored gate charge.

of MOS FET and the high drain voltage.

state to on-state.

is low.

Total Stored Gate Charge (nC)

20

15

10

5

0

04

8

12

16

20

Drain

Source

Gate

200 V

320 V

(1)

(2)

(3)

Figure 39 The Relation between Applied Gate-Source Voltage and Stored Gate Charge

The charging and discharging current caused by this gate charge makes the gate power dissipation. The relation

Where

As the gate drive current may reach up to several tenths milliamperes at 500 kHz operation, depending on the size of

MOS FET, the power dissipation caused by the gate current can not be neglected.

In this case, following action will be considered to avoid heat up of type M51995A.

(1) To attach the heat sink to type M51995A

(2) To use the printed circuit board with the good thermal conductivity

(3) To use the buffer circuit shown next section

3. Output buffer circuit

It is recommended to use the output buffer circuit as shown in figure 40, when type M51995A drives the large

capacitive load or bipolar transistor.

M51995A

Figure 40 Output Buffer Circuit Diagram