ICS574

ZERO DELAY, LOW SKEW BUFFER

ZDB

IDT™/ ICS™ ZERO DELAY, LOW SKEW BUFFER

3

ICS574

REV G 051310

External Components

The ICS574 requires a minimum number of external components for proper operation. Decoupling capacitors of

0.1µF should be connected between VDD and GND on pins 4 and 5, as close to the device as possible. A series

termination resistor of 33

Ω may be used close to the pin for each clock output to reduce reflections.

Absolute Maximum Ratings

Stresses above the ratings listed below can cause permanent damage to the ICS574. These ratings, which are

standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these

or any other conditions above those indicated in the operational sections of the specifications is not implied.

Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical

parameters are guaranteed only over the recommended operating temperature range.

Item

Rating

Supply Voltage, VDD (referenced to ground)

-0.5 V to 7 V

All Inputs and Outputs

-0.5 V to VDD+0.5 V

Electrostatic Discharge (MIl-STD-883)

2000 V (minimum)

Ambient Operating Temperature

-40

° C to +85° C

Soldering Temperature (10 seconds max.)

260

° C

Junction Temperature

150

° C

Storage Temperature

-65 to +150

° C