STM32F030R8 datasheet(20/88 Pages) STMICROELECTRONICS

20 / 88 page

Functional overview

STM32F030x4 STM32F030x6 STM32F030x8

20/88

DocID024849 Rev 1

running timer for application timeout management. It is hardware or software configurable

through the option bytes. The counter can be frozen in debug mode.

3.11.5

System window watchdog (WWDG)

The system window watchdog is based on a 7-bit downcounter that can be set as free

running. It can be used as a watchdog to reset the device when a problem occurs. It is

clocked from the APB clock (PCLK). It has an early warning interrupt capability and the

counter can be frozen in debug mode.

3.11.6

SysTick timer

This timer is dedicated to real-time operating systems, but could also be used as a standard

down counter. It features:



A 24-bit down counter



Autoreload capability



Maskable system interrupt generation when the counter reaches 0



Programmable clock source (HCLK or HCLK/8)

3.12

Real-time clock (RTC)

The RTC is an independent BCD timer/counter. Its main features are the following:



Calendar with subsecond, seconds, minutes, hours (12 or 24 format), week day, date,

month, year, in BCD (binary-coded decimal) format



Automatically correction for 28, 29 (leap year), 30, and 31 day of the month



Programmable alarm with wake up from Stop and Standby mode capability



On-the-fly correction from 1 to 32767 RTC clock pulses. This can be used to

synchronize it with a master clock.



Digital calibration circuit with 1 ppm resolution, to compensate for quartz crystal

inaccuracy



2 anti-tamper detection pins with programmable filter. The MCU can be woken up from

Stop and Standby modes on tamper event detection.



Timestamp feature which can be used to save the calendar content. This function can

triggered by an event on the timestamp pin, or by a tamper event. The MCU can be

woken up from Stop and Standby modes on timestamp event detection.



Periodic wakeup from Stop/Standby



Reference clock detection: a more precise second source clock (50 or 60 Hz) can be

used to enhance the calendar precision.

The RTC clock sources can be:



A 32.768 kHz external crystal



A resonator or oscillator



The internal low-power RC oscillator (typical frequency of 40 kHz)



The high-speed external clock divided by 32

STM32F030R8 数据表(PDF) 20 Page - STMicroelectronics

STM32F030R8 数据表(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88

数据表下载