INPUT:

The PoE extender can only receive power from an

“Ultra PoE” midspan, “Mega PoE” midspan, or

equivalent.

DC Input Voltage Range

45-57VDC

Ripple and Regulation

100mV maximum

DC Input Current

2.5A at 45VDC at maximum load

2.0A at 57VDC at maximum load

Efficiency

84% (typical) at full load and 48VDC

PoE Standard Compliance

Input

12.5K Internal Signature Resistance

Output

Detects a 25K Signature Resistance

ENVIRONMENTAL:

Temperature

Operation

-40 to +60°C

Non-operation

-40 to +85°C

Humidity

Operation

5 to 90%

Cable

Designed to operate up to 100 meters per IEEE

802.3, Cat 5e or Cat 6 rated for outdoor use

Weather Proof Enclosure

IP67 Compliant

Warranty

Limited Lifetime

Immunity

ESD:

EN61000-4-2. Level 3

RS:

EN61000-4-3. Level 3

EFT/Burst:

EN61000-4-4. Level 2

Surge:

EN61000-4-5. Level 2

CS:

EN61000-4-6. Level 2

Note: RS and CS tested with POE75U-1UP

EMC

EN55022 Class B

FCC Part 15, Class B

Isolation Test

Input to Field Ground: 2121VDC for 1 minute

Output to Field Ground: 2121VDC for 1 minute

Insulation Resistance

Input and Output to field ground: >10 OHM

500VDC

FEATURE:

Over Voltage/Current, Short Circuit Protection

Outputs equipped with short circuit protection and

overload protection as per 802.3af specification

Indicators

Ethernet

Green Full Duplex, otherwise Half

Duplex

Green 100M, otherwise 10M

Yellow blinking, Ethernet activity

POE

INPUT

On: Input power OK

Off: No power or

voltage low

OUTPUT

On: POE output OK

Off: No POE output

Input and Output Data Connector

RJ45

Input/Output Case Ports

3 ¾ NPT holes compatible with standard ¾ NPT

conduit piping or Phihong wire glands

PGLAND750/PGLAND750-2 with fully

waterproof AC and Ethernet cables.

Network Switch

Network Switch must be Environment Rated B as

per paragraph 33.4.1.1 of the IEEE802.3at standard.

POE61S-4AF Characteristics

WWW.PHIHONG.COM