E3Z

E3Z

14

Straight

XS3F-M421-402-A (L=2 m)

XS3F-M421-405-A (L=5 m)

Right Angle

XS3F-M422-402-A (L=2 m)

XS3F-M422-405-A (L=5 m)

J

M8 CONNECTOR CORDSETS

4 (0.16) dia.

9dia.

(0.35)

21.5

(0.85)

31.4

(1.24)

50 (1.97)

30

20.5

(0.81)

23.1

(0.91)

4 (0.16) dia.

50 (1.97)

9 (0.35) dia.

2.15

0.5

3.4

1.95

30

5

5

Precautions

To ensure safe sensor operation, please follow the following

precautions:

J

WIRING

Power Supply Voltage

Make sure that the power supply to the Sensor is within the rated

voltage range.

Load Short-circuiting

Do not short-circuit the load, or the Sensor may be damaged.

Polarity

Correct polarity wiring is required to prevent damage to the

sensor.

Connection Without Load

Do not connect power supply to the Sensor with no load

connected, or the internal elements may explode or burn.

J

OPERATING ENVIRONMENT

Do not use the Sensor in locations with explosive or flammable

gas.

J

SETTINGS

Power Reset Time

The Sensor is ready to operate 100 ms after the Sensor is turned

ON. If the load and Sensor are connected to independent power

supplies respectively, be sure to turn ON the Sensor before

turning the load ON.

J

CONNECTIONS

M8 Metal Connector

•

Turn off power before disconnecting the sensor.

•

Remove the connector cover before connecting or discon-

necting the metal connector.

•

Secure the connector cover by hand. Do not use any pliers,

or the connector may be damaged.

•

The proper tightening torque range is between 0.3 and 0.4

N S m. Be sure to tighten the connector securely in order to

maintain the the specified degree of protection and to keep

the connector from loosening due to vibration.

J

MOUNTING

Use M3 screws to mount the sensor and tighten each screw to a

maximum torque of 0.53 N S m.

E3Z-jjj

E39-L104 Mounting Bracket

(sold separately)