AS2525F datasheet(5/28 Pages) AMSCO

5 / 28 page

Datasheet AS2525

austriamicrosystems

Revision 2.1

Page 4 of 27

Pin #

Symbol

Type

Description

Data Output

Data output of 3-wire bus.

A 100 k

Ω resistor connected from this pin to VSS enables key locking.

If signal is not activated, a pull down resistor (100 k

Ω) is inserted.

CS1

Chip Select 1

Chip select signal for external EEPROM.

If signal is not activated, a pull down resistor (100 k

Ω) is inserted.

DI:

Digital Input

DO:

Digital Output

DI/O:

Digital Input/Output

AI:

Analogue Input

AO:

Analogue Output

AI/O:

Analogue Input/output

Basic Definitions

Password is set to 0123 and is used to access basic

parameter settings (see Table 3: Parameter settings). The

set-up programming is normally done in the factory during

manufacturing of the telephone sets. The factory settings

can be loaded into the EEPROM (see Figure 3: Memory

allocation for external EEPROM).

PIN code is default set to 1111 and is used by the user to

protect certain user settings (see Table 5: User

programming with PIN code). The PIN code can be

changed by the user.

Default settings are shown in bold.

Program procedures are entered with the [PG] key.

Pressing any invalid key or going on-hook during

programming will abort the program mode and no changes

will be stored. Ending a program procedure by pressing the

[PG] key will store the changes and exit the program mode.

Keyboard Layout

∗∗∗∗

R/P

V+

V-

Figure 1: Keyboard Layout

Maximum RON for key closure: 1 k

Ω

Minimum ROFF for open key: 1 M

Ω

See “Table 1: Key definitions” for description of key

functions

AS2525F 数据表(PDF) 5 Page - ams AG

AS2525F 数据表(HTML) 5 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载