TGP-751 datasheet(21/35 Pages) ETC2

21 / 35 page

Micropelt - preliminary - Datasheet TE-CORE /RF v1.4 | Page 21

Thermoharvesting Wireless Sensor System

Micropelt TE-CORE /RF

TE-Power SCOPE 3.0 for Windows PC

5.1 PC software application

The TE-Power CORE /RF system was designed to facili-

tate a comprehensive understanding of thermoharvest-

ing as a technology; eventually a thermogenerator will

power your application. The TE-Power SCOPE uses the

signals received from the associated TE-Power CORE /

RF system to indicate and visualize all relevant evalua-

tion aspects on a convenient graphical interface.

You can easily determine in real-time:



Temperatures and TGP voltage in a histogram

with zoom capabilities



Momentary thermal and electrical status values,

including TGP open circuit voltage, thermoelec-

trical power



Simulated charge progress of a configurable

battery (or capacitor)



Simulated power budget of a duty-cycle-

configurable attached system, which can be

hooked up to the simulated storage unit.



Data-logger function; data stored in file.

TE-Power SCOPE 3.xx accepts and visualizes the data

received from up to 5 TE- CORE /RF units.

IMPORTANT !!!

TO AVOID SOFTWARE MALFUNCTION, IT IS

STRONGLY RECOMMENDED TO FOLLOW THE

SEQUENCE DESCRIBED BELOW!

While the TE-Power SCOPE is running, removal of the

USB-receiver should be avoided. If this happens, follow

this instructions :

Click the “Stop” button, re-insert the USB receiver and

wait 5 seconds until the COM-port is allocated. Then,

verify the “Settings” to make sure that the initially se-

lected COM-port is chosen again. Close the settings

window and click “Run”.

Histogram with

measured data

Extra

functions

ID of TE-CORE /RF

Real-time

measurements

Calculated power and

battery-equivalent

5.2 Installation

Download the TE-Power SCOPE software from

the Micropelt website (zip file 1.1 MB):

http://www.micropelt.com/software/te_power_scope_core.zip

Unzip the TE_Power_SCOPE.EXE file to you PC

and execute.

Connect the USB receiver to a free USB port.

Windows automatically installs the USB-driver

(if the driver does not install automatically please

read page 17). You will need administrator access

to your computer to successful driver installation.

Select the COM-port in the “COM Settings” of

the TE-Power SCOPE. For details, refer to page

22 .

Place the TE-CORE /RF on a target surface of at

least 40 °C [104 °F].

We recommend a vertical alignment (refer to

page 18).

Press button “Run” on the TE-Power SCOPE

TGP-751 数据表(PDF) 21 Page - List of Unclassifed Manufacturers

TGP-751 数据表(HTML) 21 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35

数据表下载