Specifications are subject to change without notice.

Customers should verify actual device performance in their specific applications.

NOTE: ALL MODEL 90 PERFORMANCE SPECIFICATIONS DO NOT APPLY TO UNITS SUBJECTED TO PRINTED CIRCUIT BOARD CLEANING PROCEDURES, EXCEPT FOR THE SEALED

VERSION (MODEL 96).

1

AT ROOM AMBIENT: +25 °C NOMINAL AND 50 % RELATIVE HUMIDITY NOMINAL, EXCEPT AS NOTED.

91, 92, 93, 94, 95, 96, 99 - 5/8 ” Square Single-Turn Panel Control

99 - 5/8 ” Square Single-Turn Panel Control with Rotary Switch

Stop Strength (1/4 ” D shaft)......................................................................................................................................................................45.19 N-cm (4 lb.-in.)

(1/8 ” D shaft) ....................................................................................................................................................................33.89 N-cm (3 lb.-in.)

Mechanical Angle ........................................................................................................................................................................................................300 ° ±5 °

Torque

Starting ....................................................................................................................................................................0.3 max. above average running torque

Running Torque

Single or Dual Section (A ,D & R Bushings) ..............................................................................................................0.21 to 1.06 N-cm (0.3 to 1.5 oz.-in.)

Single or Dual Section (C & U Bushings) ..................................................................................................................0.14 to 1.06 N-cm (0.2 to 1.5 oz.-in.)

Mounting ............................................................................................................................................(Metal Bushing) 1.7-2.0 N-m (15-18 lb.-in.) maximum

Plastic Bushing) 56-79 N-cm (5-7 lb.-in.) maximum

Variation ................................................................................................................................................0.35 N-cm (0.5 oz.-in.) maximum in 45 ° shaft travel

Weight (Single Section) ..................................................................................................................................................................................7 grams maximum

(Each Additional Section) ..........................................................................................................................................................................4 grams maximum

Terminals..........................................................................................................................................................Printed circuit terminals, J-Hooks or solder lugs

Soldering Condition ......................................................................Recommended hand soldering using Sn95/Ag5 no clean solder, 0.025 ” wire diameter.

Maximum temperature 399 °C (750 °F) for 3 seconds. No wash process to be used with no clean flux.

Marking............................................................................................................Manufacturer’s trademark, date code, resistance, manufacturer’s part number

Ganging (Multiple Section Potentiometers)......................................................................................................................................................2 cups maximum

Hardware ............................................One lockwasher and one mounting nut is shipped with each potentiometer, except where noted in the part number.

Potentiometer Specifications