SPECIFICATION FOR APPROVAL

DOCUMENT

: RLI00000N

REVISION

: A1

PAGE

: 4 OF 11

5. Characteristics

5-1 Electrical

5-1-1 Resistance and tolerance

Resistance value shall be within the tolerance specified in paragraph 4-1

Refer to IEC 60115-1 Sub-clause 4.5.

5-1-2 Temperature Coefficient of Resistance

Not exceed the temperature coefficient of resistance specified in paragraph 4-1

Room temperature

→ Room temperature + 100℃

Refer to IEC 60115-1 Sub-clause 4.13.

5-1-3 Short Time Overload

Resistance Change :

± (0.5%)

Without significant damage by flashover (spark ,arching),burning or breakdown etc.

Test voltage : 2.5 times the rated voltage.

Duration : 5 seconds

Refer to IEC 60115-1 Sub-clause 4.13.

5-1-4 Insulation Resistance

(1) Between Electrode and Protection Film

100M

Ω or over

(2) Between Electrode and Substrate

1,000M

Ω or over

The resistor shall be cramped in the metal block and tested , as shown below.

Test voltage : 100

± 15V

Refer to IEC 60115-1 Sub-clause 4.6.

Insulation Plate

Spring

Sample Electrode

Metal Block

Measurement Point B

Pressure Rod

(Metal)

Measurement Point A

Substrate

Over coat Film

(R0.25mm ~ R0.5mm)

A

B

Voltage Supply

Substrate Side