LM4865

SNAS035G – DECEMBER 1999 – REVISED MAY 2013

www.ti.com

HP-Sense FUNCTION

mutes a bridged-connected load. Quiescent current consumption is reduced when the IC is in this single-ended

mode.

Figure 30 shows the implementation of the LM4865's headphone control function. With no headphones

connected to the headphone jack, the R1-R2 voltage divider sets the voltage applied to the HP-Sense pin (pin 3)

at approximately 50mV. This 50mV enables the LM4865 and places it in bridged mode operation.

While the LM4865 operates in bridged mode, the DC potential across the load is essentially 0V. Since the HP-

Sense threshold is set at 4V, even in an ideal situation, the output swing cannot cause a false single-ended

mutes the bridged speaker. The amplifier then drives the headphones, whose impedance is in parallel with

resistor R2. Resistor R2 has negligible effect on output drive capability since the typical impedance of

headphones is 32

Ω. The output coupling capacitor blocks the amplifier's half supply DC voltage, protecting the

headphones.

A microprocessor or a switch can replace the headphone jack contact pin. When a microprocessor or switch

applies a voltage greater than 4V to the HP Sense pin, a bridge-connected speaker is muted and Amp1 drives

the headphones.

PROPERLY SELECTING EXTERNAL COMPONENTS

Optimizing the LM4865's performance requires properly selecting external components. Though the LM4865

operates well when using external components having wide tolerances, the best performance is achieved by

optimizing component values.

Figure 30. Headphone Circuit

Input Capacitor Value Selection

Amplification of the lowest audio frequencies requires high value input coupling capacitors. These high value

capacitors can be expensive and may compromise space efficiency in portable designs. In many cases,

however, the speakers used in portable systems, whether internal or external, have little ability to reproduce

signals below 150Hz. In application 5 using speakers with this limited frequency response, a large input capacitor

will offer little improvement in system performance.

using Equation 4.

(4)

12

Submit Documentation Feedback

Copyright © 1999–2013, Texas Instruments Incorporated

Product Folder Links: LM4865