ABSOLUTE MAXIMUM RATINGS

Storage Temperature

HOW TO ORDER HTXO SURFACE MOUNT CRYSTAL OSCILLATORS

HTXO

4

B

S

N

SM5

20.0M ,

/

/

500

/

W

STATEK CORPORATION 512 N. MAIN ST., ORANGE, CA 92868 714-639-7810 FAX: 714-997-1256 www.statek.com

10214 Rev B

SPECIFICATIONS

Specifications are subject to change without notice. Tighter

specifications available, please contact factory.

3.3 V ±5%

5.0 V ±10%

Output Load (CMOS)

15 pF

Start-up Time

5 ms MAX

Rise/Fall Time

10 ns MAX

40% MIN, 60% MAX

Up to 30,000 g, 0.5 ms, ½ sine

20 g, 10-2000 Hz, swept sine

-55ºC up to 250ºC

1. 30 MHz maximum @ 3.3 V ±5%.

2. Frequency over temperature relative to nominal frequency.

3. 45% MIN, 55% MAX available. Check with factory.

4. 25ºC

5. Per MIL-STD-202G, Method 204D, Condition D, Random vibration testing also available.

PACKAGING OPTIONS

HTXO

- Tray Pack

- Tape and Reel

- 16 mm tape, 7” or 13” reels

Per EIA 481 (see Tape and Reel data

sheet # 10109)

Frequency

M = MHz

Termination

Blank = SM1

=Gold Plated (Pb Free)

SM5 = Solder Dipped (Pb Free)

Shock Level

A = 5,000 g

B = 10,000 g

C = 20,000 g

D = 30,000 g

Supply Voltage

4 = 3.3V

5 = 5.0V

Enable/Disable

Option T or N

Blank = Standard

S = Special or

custom

ENABLE/DISABLE OPTIONS (T/N)

Statek offers two enable/disable options: T and N. The T-

version has a Tri-State output and oscillates internally when

the output is put into the high Z state. The N-version does

not have PIN 1 connected internally and has no

enable/disable capability. The following table describes the

Enable/Disable option T.

COMPARISON OF

ENABLE/DISABLE OPTIONS T AND N

TN

When enabled (PIN 1 is low)

Output

Freq. output

Freq. output

Oscillator

Oscillates

Oscillates

Current consumption

Normal

Normal

When disabled (PIN 1 is high)

Output

High Z state

N/C

Oscillator

Oscillates

N/C

Current consumption

Lower than normal

N/C

Temp. Range:

S = Customer

Specified Temp. Range

Total Frequency

Tolerance (in

ppm)