LPC2104FBD48SLASH01 datasheet(18/41 Pages) PHILIPS

18 / 41 page

LPC2104_2105_2106_7

Product data sheet

Rev. 07 — 20 June 2008

18 of 41

NXP Semiconductors

LPC2104/2105/2106

Single-chip 32-bit microcontrollers

6.12 SPI serial I/O controller

The SPI is a full duplex serial interface, designed to be able to handle multiple masters

and slaves connected to a given bus. Only a single master and a single slave can

communicate on the interface during a given data transfer. During a data transfer the

master always sends a byte of data to the slave, and the slave always sends a byte of data

to the master.

6.12.1 Features

• Compliant with Serial Peripheral Interface (SPI) speciﬁcation.

• Synchronous, serial, full duplex communication.

• Combined SPI master and slave.

• Maximum data bit rate of one eighth of the input clock rate.

6.12.2 Features available in LPC2104/2105/2106/01 only

• Selectable transfer width of eight to 16 bit per frame.

• When the SPI interface is used in Master mode, the SSEL pin is not needed (can be

used for a different function).

6.13 SSP controller (LPC2104/2015/2106/01 only)

The SSP is a controller capable of operation on a SPI, 4-wire SSI, or Microwire bus. It can

interact with multiple masters and slaves on the bus. Only a single master and a single

slave can communicate on the bus during a given data transfer. Data transfers are in

principle full duplex, with frames of four to 16 bits of data ﬂowing from the master to the

slave and from the slave to the master.

Because the SSP and SPI peripherals share the same physical pins, it is not possible to

have both of these two peripherals active at the same time. Application can switch on the

ﬂy from SPI to SSP and back.

6.13.1 Features

• Compatible with Motorola’s SPI, Texas Instrument’s 4-wire SSI, and National

Semiconductor’s Microwire buses.

• Synchronous serial communication.

• Master or slave operation.

• 8-frame FIFOs for both transmit and receive.

• Four to 16 bits per frame.

6.14 General purpose timers

The Timer is designed to count cycles of the peripheral clock (PCLK) and optionally

generate interrupts or perform other actions at speciﬁed timer values, based on four

match registers. It also includes up to four capture inputs to trap the timer value when an

input signal transitions, optionally generating an interrupt.

LPC2104FBD48/01 数据表(PDF) 18 Page - NXP Semiconductors

LPC2104FBD48/01 数据表(HTML) 18 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

数据表下载