OLED Display

www.nkk.com

E7

E

PRECAUTIONS FOR HANDLING & STORAGE OF OLED DEVICES

Handling

1. The IS Series OLED devices are electrostatic sensitive. To avoid damage to IC, do not touch terminals unless

properly isolated from static electricity.

2. Signal input under conditions not recommended may cause damage to the OLED unit or deterioration of the

display. Follow directions regarding supply sequences of power and signal voltages.

3. If the OLED panel is broken, avoid touching the contents. Wash off any contact to the skin or clothing.

4. Limit operating force to switch keytop to 100.0N maximum, as excessive pressure may damage the OLED.

5. For OLED display, it is necessary for bracket legs to be Grounded.

6. Recommended soldering time and temperature limits for OLED switch or display:

Wave Soldering: see Profile A in Supplement section.

Manual Soldering: see Profile A in Supplement section.

A

void temperatures exceeding 80°C at the OLED.

7. The IS series OLED devices are not process sealed.

8. Pixels acquire diminished brightness over time and use, and those most frequently habituated have greater

reduction of brightness than those less used. To minimize this difference, operate OLED unit so that all pixels

are used as consistently as possible.

9. For switch, clean cap surface with dry cloth. If further cleaning is needed, wipe with dampened cloth using

neutral cleanser and dry with clean cloth. Do not use organic solvent. For display, avoid contact with any

flux or detergent. If any liquids spill on display surface, immediately wipe with soft absorbent cloth.

Storage

1. Store in original container and away from direct sunlight.

2. Keep away from static electricity.

3. Avoid extreme temperatures, high humidity, gaseous substances, and all forms of chemical contamination.

ATTENTION

ELECTROSTATIC

SENSITIVE DEVICES