5-545

FAST AND LS TTL DATA

SN54/74LS390

• SN54/74LS393

PIN NAMES

LOADING (Note a)

HIGH

LOW

CP

Clock (Active LOW going edge)

Input to +16 (LS393)

0.5 U.L.

1.0 U.L.

CP0

Clock (Active LOW going edge)

Input to

÷2 (LS390)

0.5 U.L.

1.0 U.L.

CP1

Clock (Active LOW going edge)

Input to

÷5 (LS390)

0.5 U.L.

1.5 U.L.

MR

Master Reset (Active HIGH) Input

0.5 U.L.

0.25 U.L.

Q0 – Q3

Flip-Flop outputs (Note b)

10 U.L.

5 (2.5) U.L.

NOTES:

a) 1 TTL Unit Load (U.L.) = 40

µA HIGH/1.6 mA LOW.

b) The Output LOW drive factor is 2.5 U.L. for Military (54) and 5 U.L. for Commercial (74)

FUNCTIONAL DESCRIPTION

Each half of the SN54 / 74LS393 operates in the Modulo 16

binary sequence, as indicated in the

÷16 Truth Table. The first

flip-flop is triggered by HIGH-to-LOW transitions of the CP

input signal. Each of the other flip-flops is triggered by a

HIGH-to-LOW transition of the Q output of the preceding

flip-flop. Thus state changes of the Q outputs do not occur

simultaneously. This means that logic signals derived from

combinations of these outputs will be subject to decoding

spikes and, therefore, should not be used as clocks for other

counters, registers or flip-flops. A HIGH signal on MR forces

all outputs to the LOW state and prevents counting.

Each half of the LS390 contains a

÷5 section that is

independent except for the common MR function. The

÷5

section operates in 4.2.1 binary sequence, as shown in the

÷5

Truth Table, with the third stage output exhibiting a 20% duty

cycle when the input frequency is constant. To obtain a

÷10

function having a 50% duty cycle output, connect the input

signal to CP1 and connect the Q3 output to the CP0 input; the

Q0 output provides the desired 50% duty cycle output. If the

input frequency is connected to CP0 and the Q0 output is

connected to CP1, a decade divider operating in the 8.4.2.1

BCD code is obtained, as shown in the BCD Truth Table. Since

the flip-flops change state asynchronously, logic signals

derived from combinations of LS390 outputs are also subject

to decoding spikes. A HIGH signal on MR forces all outputs

LOW and prevents counting.

SN54 / 74LS390 LOGIC DIAGRAM (one half shown)

SN54 / 74LS393 LOGIC DIAGRAM (one half shown)

CP1

CP0

MR

MR

CP

K CP J

CD

Q

K CP J

CD

Q

K CP J

CD

Q

K CP J

CD

Q

K CP

J

CD

Q

K CP J

CD

Q

K CP J

CD

Q

K CP J

CD

Q

Q0

Q0

Q1

Q1

Q2

Q2

Q3

Q3