CS52845 datasheet(4/6 Pages) CHERRY

4 / 6 page

Undervoltage Lockout

During Undervoltage Lockout (Figure 1), the output driv-

er is biased to sink minor amounts of current. The output

should be shunted to ground with a resistor to prevent

activating the power switch with extraneous leakage cur-

rents.

PWM Waveform

To generate the PWM waveform, the control voltage from

the error amplifier is compared to a current sense signal

which represents the peak output inductor current (Figure

2). An increase in VCC causes the inductor current slope to

increase, thus reducing the duty cycle. This is an inherent

feed-forward characteristic of current mode control, since

the control voltage does not have to change during

changes of input supply voltage.

When the power supply sees a sudden large output cur-

rent increase, the control voltage will increase allowing

the duty cycle to momentarily increase. Since the duty

cycle tends to exceed the maximum allowed to prevent

transformer saturation in some power supplies, the inter-

nal oscillator waveform provides the maximum duty cycle

clamp as programmed by the selection of OSC compo-

nents.

Figure 1: Startup voltage for the CS52845.

Circuit Description

Test Circuit Open Loop Laboratory Test Fixture

VREF

VCC

VOUT

1kΩ

0.1µF

VREF

VCC

VOUT

Gnd

VFB

Sense

OSC

COMP

5kΩ

100kΩ

4.7kΩ

1kΩ

Error Amp

Adjust

4.7kΩ

Sense

Adjust

2N2222

Gnd

VCC

VON = 8.4V

VOFF = 7.6V

ON/OFF Command

to reset of IC

<15mA

<1mA

VON

VOFF

ICC

VCC

CS52845 数据表(PDF) 4 Page - Cherry Semiconductor Corporation

CS52845 数据表(HTML) 4 Page - Cherry Semiconductor Corporation

Html Pages

1 2 3 4 5 6

数据表下载