128240D SERIES

Version : 1.2 P 21 of 21

◆

Storage

When storing LCDs as spares for some years, the following precautions are necessary.

1. Store them in a sealed polyethylene bag. If properly sealed, there is no need for desiccant.

2. Store them in a dark place. Do not expose to sunlight or fluorescent light, keep the temperature between 0°C and 35°C.

3. The polarizer surface should not come in contact with any other objects. (We advise you to store them in the container in

which they were shipped.)

4. Environmental conditions:

•

Do not leave them for more than 168hrs. at 60°C.

•

Should not be left for more than 48hrs. at -20°C.

◆

Safety

1. It is recommended to crush damaged or unnecessary LCDs into pieces and wash them off with solvents such as acetone and

ethanol, which should later be burned.

2. If any liquid leaks out of a damaged glass cell and comes in contact with the hands, wash off thoroughly with soap and

water.

◆

Limited Warranty

Unless agreed between DISPLAYTECH and customer, DISPLAYTECH will replace or repair any of its LCD modules that

are found to be functionally defective when inspected in accordance with DISPLAYTECH LCD acceptance standards (copies

available upon request) for a period of one year from date of shipments. Cosmetic/visual defects must be returned to

DISPLAYTECH within 90 days of shipment. Confirmation of such date shall be based on freight documents. The warranty

liability of DISPLAYTECH limited to repair and/or replacement on the terms set forth above. DISPLAYTECH will not be

responsible for any subsequent or consequential events.

◆

Return LCM under warranty

No warranty can be granted if the precautions stated above have been disregarded. The typical examples of violations are :

•

Broken LCD glass.

•

PCB eyelet’s damaged or modified.

•

PCB conductors damaged.

•

Circuit modified in any way, including addition of components.

•

PCB tampered with by grinding, engraving or painting varnish.

•

Soldering to or modifying the bezel in any manner.

Module repairs will be invoiced to the customer upon mutual agreement. Modules must be returned with sufficient

description of the failures or defects. Any connectors or cable installed by the customer must be removed completely without

damaging the PCB eyelet’s, conductors and terminals.

 REVISION RECORD

VERSION

CHANGES

DATE

1.0

Initial revision

29 July 2008

1.1

Add Remark on page 3

2 October 2008

1.2

Correct the VLCD voltage to 15.5V (page 3)

12 December 2011