• North America Tel: 800.366.2266 / Fax: 978.366.2266

• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300

• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298

Visit www.macomtech.com for additional data sheets and product information.

M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make

changes to the product(s) or information contained herein without notice.

3

High Power GaAs DPDT Diversity Switch

DC - 4.0 GHz

Rev. V1

MASWSS0184

ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions

is considering for development. Performance is based on target specifications, simulated results,

and/or prototype measurements. Commitment to develop is not guaranteed.

PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology

Solutions has under development. Performance is based on engineering tests. Specifications are

typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.

Commitment to produce in volume is not guaranteed.

Evaluation Board for 3 mm 12-Lead PQFN

C4

C3

C1

C2

U1

C4

C3

C1

C2

U1

Truth Table

7,8

7.

Differential voltage, V (state 1) - V (state 0), must be

+2.7 V minimum and must not exceed 8.0 V.

8.

1 = +2.9 V to +8 V, 0 = 0 V + 0.2 V.

Control

Control

ANT 1

- Rx

ANT 1

- Tx

ANT 2

- Tx

ANT 2

- Rx

1

0

On

Off

On

Off

0

1

Off

On

Off

On

Absolute Maximum Ratings

5,6

5. Exceeding any one or combination of these limits may cause

permanent damage to this device.

6. M/A-COM does not recommend sustained operation near

these survivability limits.

Parameter

Absolute

Maximum

Input Power @ 3 V Control

+35 dBm CW

Input Power @ 5 V Control

+37 dBm CW

Voltage

≤ 8 volts

Operating Temperature

-40°C to +85

Storage Temperature

-65

Qualification

Qualified

to

M/A-COM

specification

REL-201,

Process Flow –2.

Handling Procedures

Please observe the following precautions to avoid

damage:

Static Sensitivity

Gallium Arsenide Integrated Circuits are sensitive

to electrostatic discharge (ESD) and can be

damaged by static electricity. Proper ESD control

techniques should be used when handling these

devices.

Application Schematic

GND

GND

GND

Vc2

Vc1

GND

C1

C2

C3

C4

C1 = C2 = C3 = C4 = 39 pF