S6010LS3 datasheet(10/12 Pages) ETC2

10 / 12 page

Sensitive SCRs

Data Sheets

http://www.littelfuse.com

E5 - 10

+1 972-580-7777

Thyristor Product Catalog

Figure E5.17 Power Dissipation (Typical) versus RMS On-state Current

Figure E5.18 Normalized DC Latching Current versus Case Temperature

Figure E5.19 Simple Test Circuit for Gate Trigger Voltage and

Current Measurement

Note: V1 — 0 V to 10 V dc meter

VGT — 0 V to 1 V dc meter

IG — 0 mA to 1 mA dc milliammeter

R1 — 1 k potentiometer

To measure gate trigger voltage and current, raise gate voltage

(VGT) until meter reading V1 drops from 6 V to 1 V. Gate trigger

voltage is the reading on VGT just prior to V1 dropping. Gate trig-

ger current IGT can be computed from the relationship

where IG is reading (in amperes) on meter just prior to V1 drop-

ping.

Note: IGT may turn out to be a negative quantity (trigger current

flows out from gate lead). If negative current occurs, IGT value is

not a valid reading. Remove 1 k resistor and use IG as the more

correct IGT value. This will occur on 12 µA gate products.

02468

RMS On-state Current [IT(RMS)] – Amps

CURRENT WAVEFORM: Half Sine Wave

LOAD: Resistive or Inductive

CONDUCTION ANGLE: 180˚

6 A to 10 A

TO-220, TO-202,

TO-251, and TO-252

-65

-15

+25

+65

+110 +125

-40

1.0

2.0

3.0

4.0

5.0

6.0

7.0

8.0

9.0

Case Temperature (TC) – ˚C

See General Notes for specific device

operating temperature range.

6 V

–

100

D.U.T.

Reset

Normally-closed

Pushbutton

1 k

(1%)

100

IN4001

IGT

VGT

1000

------------- Amps

–

S6010LS3 数据表(PDF) 10 Page - List of Unclassifed Manufacturers

S6010LS3 数据表(HTML) 10 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

数据表下载