FEDL2280XFULL-04

ML22808/ML22804/Ml22802-XXX

9.

CLOOP command

• command

1

0

0

1

⎯

⎯

⎯

⎯

The CLOOP command releases repeat playback mode.

When repeat playback mode is released, NCR goes “H”.

It is possible to input the CLOOP command

regardless of the NCR status during playback, but a prescribed command interval needs taking.

CLOOP Command Input Timing

Depending on the timing of the CLOOP command input during repeat playback, the repeat playback will end

either at the end of the currently playing phrase or after one more repetition of the phrase.

The repeat playback will end at the currently playing phrase at the CLOOP command input timing shown in the

table below.

Playback method

CLOOP input timing

Amount of remaining voice data in the phrase being played

4-bit ADPCM2

35 samples or more

8-bit nonlinear/straight PCM

18 samples or more

16-bit straight PCM

18 samples or more

In 4-bit ADPCM2, if the CLOOP command is input 35 or more samples earlier than the time when playback of 1

phrase ends, repeat playback will end with that phrase.

If the command is input after the amount of remaining

voice data becomes less than 35 samples, playback of the phrase will be repeated once more.

1 phrase

35 samples

1 phrase

If the command is input at this timing, playback

of the phrase will be repeated once more.

In 8-bit nonlinear/straight PCM or 16-bit straight PCM, if the CLOOP command is input 18 or more samples

earlier than the time when playback of 1 phrase ends, repeat playback will end with that phrase.

If the

command is input after the amount of remaining voice data becomes less than 18 samples, playback of the

phrase will be repeated once more.

1 phrase

18 samples

If the command is input at this timing, playback

will end with this phrase.

35/41