ST7232A datasheet(155/157 Pages) STMICROELECTRONICS

155 / 157 page

ST7232A

155/157

DEVICE CONFIGURATION AND ORDERING INFORMATION (Cont’d)

tion is not doing anything between the idle and the

break. This can be ensured by temporarily disa-

bling interrupts.

The exact sequence is:

- Disable interrupts

- Reset and Set TE (IDLE request)

- Set and Reset SBK (Break Request)

- Re-enable interrupts

15.1.6 39-Pulse ICC Entry Mode

For Flash devices, ICC mode entry using ST7 ap-

plication clock (39 pulses) is not supported. Exter-

nal clock mode must be used (36 pulses). Refer to

the ST7 Flash Programming Reference Manual.

15.2 ROM DEVICES ONLY

15.2.1 I/O Port A and F Configuration

When using an external quartz crystal or ceramic

resonator, a few fOSC2 clock periods may be lost

when the signal pattern in Table 31 occurs . This is

because this pattern causes the device to enter

test mode and return to user mode after a few

clock periods. User program execution and I/O

status are not changed, only a few clock cycles are

lost.

This happens with either one of the following con-

figurations:

PA3=0, PF4=1, PF1=0 while PLL option is disa-

bled and PF0 is toggling

PA3=0, PF4=1, PF1=0, PF0=1 while PLL option is

enabled

This is detailed in the following table

Table 31. Port A and F Configuration:

As a consequence, for cycle-accurate operations,

these configurations are prohibited in either input

or output mode.

Workaround:

To avoid this occurring, it is recommended to con-

nect one of these pins to GND (PF4 or PF0) or

VDD (PA3 or PF1).

15.2.2 External clock source with PLL

PLL is not supported with external clock source.

PLL PA3 PF4 PF1

PF0

Clock

Disturbance

OFF

010

Toggling

Max. 2 clock cy-

cles lost at each

rising or falling

edge of PF0

010

Max. 1 clock cy-

cle lost out of

every 16

ST7232A 数据表(PDF) 155 Page - STMicroelectronics

ST7232A 数据表(HTML) 155 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载