12/17/07

SP7600 Evaluation Board Manual

© 2007 Exar Corporation

Page 2 of 5

_______________________________________________ USING THE EVALUATION BOARD

1) Powering Up the SP7600 Circuit

The SP7600 Evaluation Board can be powered from a 4.5V to 29V power supply. Connect the power

supply with short leads directly to the “Vin” and “GND” posts.

2) Setting the output current

Externally connected LEDs need to be connected anode to the VOUT pin and cathode to the Vfb pin. As

many as 6 series connected LEDs may be used, depending on the input voltage range available. The

maximum output current is 3A but the user should take care not to exceed the maximum junction

temperature, 125°C. Up to 2A maximum is possible in almost all conditions. The board also has SMT

pads available for LEDs to be mounted in the LED1 position for a Luxeon K2 LED, and LED2, LED3 and

LED4 positions for Luxeon Rebel LEDs. The total output current of the SP7600 is controlled by the VFB

pin voltage setpoint of 200mV. Use a resistor at RA to set the output current by the formula:

Iout = Vfb/RA

where RA is the parallel combination of Ra and any of the resistors Rb, Rc or Rd.

If Ra, Rb, Rc and Rd are used then RA = 1/(1/Ra + 1/Rb + 1/Rc + 1/Rd)

Standard SP7600EB Evaluation Board Example:

Iout = Vfb/RA = 200mV/0.22ohm = 1A

3) Dimming

The SP7600 can be pulse width modulated using a signal applied to the DIM post. The DIM signal

connects to the VFB pin through a 1N4148 diode and will shutdown the SP7600 when DIM = H and turn-

on the SP7600 when DIM = L. The DIM signal needs to be greater than 600mV minimum to turn-off the

SP7600 and less than 200mV to fully turn-on the SP7600. It is recommended to use a signal with DIM =

1V or more for OFF and 0V for ON. The user should note that the logic is reversed relative to many

other PWM controlled LED drivers. In other words a logic level high at 20% duty cycle will result in

approximately an 80% duty cycle for the LED. Recommended modulation frequencies are from 100Hz to

200Hz with 10 – 90% duty cycle, 500Hz with 10 – 80% duty cycle, and 1000Hz with 10 – 70% duty cycle.

Figures 2 & 3 show the output response at the maximum PWM DIM signal of 1000Hz. See figure 4 for

100Hz to 1000Hz duty cycle response for two Luxeon K2 LEDs in parallel at 2A total current.