HDM8513AP datasheet(21/67 Pages) HYNIX

21 / 67 page

signal level variations. An analog wideband AGC is also employed to insure that the analog signal

applied to the A/D converters is properly scaled.

Both the symbol timing and carrier tracking loops are implemented digitally, which eliminates the

need for external connections to analog tuning components during steady state operation. This

causes the requirements on the analog presampling filter to be relaxed, permitting a lower cost

analog front end. For systems which require a narrowband presampling filter, and have the potential

for significant frequency error in the LNB (several MHz) the HDM8513A provides a high resolution

measure of carrier frequency to permit periodic readjustment of the front end tuner frequency to

compensate for drift. The host processor periodically reads the frequency register, then computes

appropriate correction to the tuner frequency.

The nominal symbol rate and the nominal carrier frequency are programmed into the demodulator

to an accuracy provided by 20 bits of resolution, and the system accuracy is equivalent to that of

the fixed frequency sampling clock.

During initial acquisition, the HDM8513A provides an automated sweep program to facilitate carrier

acquisition. The host processor loads a 20 bit register which determines the initial carrier

frequency. A 16 bit register is programmed with the number of symbol times the receiver will dwell

at each frequency. If the receiver remains at the initial frequency for the programmed number of

symbol times without achieving lock, the carrier frequency is incremented by the step frequency

value programmed into another 16 bit register. If no lock is achieved, the receiver will continue to

increment the frequency until the maximum number of search frequencies, as determined by the

value in an eight bit register, is achieved. When the maximum number of search frequencies is

reached, the carrier frequency returns to the initial value and the entire process is repeated. Once

the host processor determines that lock is achieved by observing the lock flag, it then inhibits the

sweep function and programs loop bandwidth parameters which are optimized for steady state

performance.

HDM8513AP 数据表(PDF) 21 Page - Hynix Semiconductor