4 built-in communications ports (2-DB9, 2-USB) for remote monitoring and unattended shutdown

Slot for SNMP/web card (part#: SNMPWEBCARD) and environmental sensor (part#: ENVIROSENSE) for remote communications in large IP

environments

Supports Tripp Lite's WatchDog software application to restore unresponsive programs by automatically restarting them and rebooting completely locked

computers by automatically switching UPS power off and back on again

Communication ports support on battery, low battery, power restored, AC line voltage, DC battery voltage, load percentage, battery charge current,

battery capacity, internal UPS temperature and line frequency status messaging. Interface supports timed inverter shutoff after unattended shutdown,

activate self-test and 10 second reboot of connected equipment

3 individual customized load management receptacles can be individually powered off and back on again via software interface to reboot remote

equipment or perform "load shedding" of less critical loads to extend battery runtime for the most critical equipment

Built-in Emergency Power Off (EPO) interface supports emergency shutoff in large facilities

Hot-swappable/user replaceable batteries allow on-site battery replacement without powering off connected equipment

UPS battery set ships fully assembled and ready for use, no time consuming, connection of individual internal batteries by user is necessary

Specifications

OUTPUT

Output Capacity Details

Output capacity is limited to 1600 watts in all external battery pack configurations

Output Volt Amp Capacity (VA)

3000

Output kVA Capacity (kVA)

3

Output Watt Capacity (Watts)

2250

Output kW Capacity (kW)

2.2

Power Factor

0.8

Nominal Output Voltage(s)

Supported

120V

Frequency Compatibility

60 Hz

Output Voltage Regulation (Line

Mode)

-18% / +8%

Output Voltage Regulation (Battery

Mode)

+/- 5%

Output Receptacles

(7) 5-15R; (2) 5-15/20R; (1) L5-30R

Load Management Receptacles

Three switchable two-outlet 5-15R load banks

Output Circuit Breakers

20A branch rated (x2) - breaker 1 protects 5-20R, breaker 2 protects 5-15R, L5-30R is unbreakered

Output AC Waveform (AC Mode)

Sine wave

Output AC Waveform (Battery Mode)

PWM sine wave

INPUT

Rated input current (Maximum Load)

24A

Nominal Input Voltage(s) Supported

120V AC

2 / 5