ST10Flasher settings

AN2143

2/8

1

ST10Flasher settings

This section describes the steps required for programming the ST10F27x embedded Flash

using the ST10Flasher.

To use this document, the ST10Flasher must be already installed on the development host.

For more details on ST10Flasher installation, refer to the readme.txt file included in the

ST10Flasher tool package.

1.1

Starting ST10Flasher

ST10Flasher runs on a PC connected to the ST10F27x target microcontroller via an RS232

interface.

●

Enter the standard bootstrap mode by forcing P0L.4 to 0 and P0L.5 to 1

●

Reset the ST10

●

Select Start -> Programs -> ST10-Flasher-2.4

ST10Flasher starts and the following window appears: