DocID024146 Rev 1

5/17

UM1599

Getting started

3

Getting started

To start working with the STPM01 or STPM1x demonstration board, follow the below steps:

1.

Connect the demonstration board to the parallel hardware programmer or to the USB

programmer (STEVAL-IPE023V1)

2.

Connect the programmer to the PC through a parallel or a USB cable

3.

Power on the demonstration board

4.

Open the STPM1x evaluation software

5.

Select the menu Option - Interface - Parallel or Serial according to the chosen

hardware programmer (see Section 4.2)

6.

Configure the application parameters selecting Option - Configuration menu (see

Section 4.2)

7.

The user is now ready to read, write (see Section 5.6) or calibrate your application (see

Section 4.3)