UM0582

Operation of the STEVAL-TLL005V1 demonstration board

Doc ID 14969 Rev 1

13/24

Any running sequence (flash/torch/auxiliary LED) can be aborted by pressing the STOP

button on the GUI.

Also, users can create their own sequences by inserting different combinations of flash,

torch and auxiliary LED.

When creating custom sequences, keep in mind these things.

–

When the STCF03 uses its internal timer, the microcontroller must wait. Therefore,

do not forget to use WAIT after the flash and the aux LED initialization

–

When initializing a flash, do not forget to set the TRIG pin to HIGH

–

“Add/insert ready" and "add/insert shutdown" takes the STF03 into a “ready” and

“shutdown” state, respectively

3.1.4

Using Register_Controller.EXE

Run the Register_Controller.EXE. The main window of the application is shown in

Figure 12. The GUI shows the bits of the different configuration registers

(Command/Dimming/Auxiliary/Status registers).

Follow the steps below to run the board using Register_Controller:

1.

Press the "Scan COM ports for the demo board" button. The program automatically

detects to which port the demonstration board is connected, or the port can be set up

manually by pressing the "RS-232 Communication setup" button. To ensure proper

functioning, no other communication parameters should be changed.

2.

RS-232 communication can be tested by pressing the "Test RS-232 communication"

button.

3.

correct.

4.

This button makes the auxiliary LED (red) glow on daughterboard.

5.

Users can now configure the board in any of the allowed modes (flash/torch/Auxiliary

mode) to run the application.

Figure 11.

Slider to configure the auxiliary LED