Test board: design and evaluation

AN4007

16/33

Doc ID 022455 Rev 2

Figure 16.

1.6

Dynamic step load regulation

In any power supply it is important to measure the output voltage when the converter is

submitted to dynamic load variations, in order to be sure that good stability is ensured and

no overvoltage on undervoltage occurs.

The board under evaluation was submitted to dynamic load variations from 0 to 50% loads

(

Figure 17), from 50% to 100% loads (Figure 18) and from 0 to 100% loads (Figure 19).

In any tested condition, no abnormal oscillations were noticed on the output and the

over/undershoot were well within acceptable values.

AM11355v1

Ch1 (Pk-Pk): 27.27 mV

Ch2 (Pk-Pk): 64.68 mV

M: 400.0 µs/div