UM1541

Use of the demo with a connection to a PC

Doc ID 023169 Rev 1

5/7

2

Use of the demo with a connection to a PC

1.

Step 1: connect the boards together according to Figure 3.

2.

Step 2: remove the 5 V-P5 V jumper and put the switch into the left position according

to Figure 5.

Figure 5.

Jumper and switch configuration for use with a PC

3.

Step 3: connect power supply or battery to the power supply connector of the

daughterboard only. The control board is supplied from the USB.

4.

Step 4: connect the board to the PC by the USB cable (AB type).

5.

Step 5: run the data packet creator or register controller application and press the

“Connect board” button.

AM12235v1

This jumper

must be opened

This switch must

be in the left position