| 数据搜索系统,热门电子元器件搜索 |
|
AN2415 数据表(PDF) 5 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
AN2415 数据表(HTML) 5 Page - STMicroelectronics |
|
5 / 11 page ![]() AN2415 Operation mode switching 5/11 2 Operation mode switching To enter Error Detection or Normal mode, the drivers must receive a particular sequence on the OE and LE pins. When a one-clock-wide short pulse “101” is sent on the OE pin, the drivers enter the switching phase. If the LE pin is sampled as high voltage at the 4th rising edge of CLK, the drivers switch to Error Detection mode (Figure 3). Otherwise, they switch to Normal mode (Figure 4). Note: In the firmware, with SW2 pressure only the drivers enter Error Detection mode, and after an error detection check, they re-enter Normal mode. Figure 3. Error Detection mode Figure 4. Normal mode 2.1 Normal mode In Normal mode, the serial data is transferred from the microcontroller to the drivers via the SPI. The serial data from microcontroller is sent to the drivers via the SDI pin, undergoes a shift in the Shift Register, and exits via the SDO pin. The LE pin can latch the serial data in the Shift Register to the output latch. The OE pin enables the output driver sink current. Current is modulated by the potentiometer, which changes the PWM duty cycle on the OE pin (PWM frequency is set at 244 Hz). |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |