AN3985 datasheet(21/105 Pages) STMICROELECTRONICS

21 / 105 page

AN3985

CR95HF low level layer

Doc ID 022255 Rev 2

21/105

CR95HF_Rd_Analog_Register_Config_B function

This function reads the analog register configuration B of the CR95HF to check the analog

configuration Register containing the modulation depth and reader chain gain.

Note:

A CR95HF_Set_Analog_Register_Config_B_Index command must be issued before

reading the register.

CR95HF_Baud_Rate function

This function sends a BaudRate command to the CR95HF. It allows to configure the UART

baudrate.

Table 21.

CR95HF_Rd_Analog_Register_Config_B function description

Prototype

u8 CR95HF_Rd_Wake_up_Reg(CR95HF_ResponseReceiving*

Response,CR95HF_Idle_Config* Idle_Config);

Input parameter

None

Output parameter

Response: pointer on the structure to fill in with the data retrieved

Idle_Config: pointer on the structure to update

Return parameter

CR95HF_SUCCESS_CODE: The command is successful.

CR95HF_ERROR_INVALID_CMD_LENGTH: The command failed,

invalid length

CR95HF_ERROR_CODE: Unsuccessful command, Response

contains the error code.

Table 22.

CR95HF_Baud_Rate function description

Prototype

u8 CR95HF_Baud_Rate(u8 New_Baud_Rate);

Input parameter

New_Baud_Rate: new baud rate = 13.56/(2*BaudRate+2) Mbps

Output parameter

pResponse: pointer on the CR95HF response

Return parameter

CR95HF_SUCCESS_CODE: The command is successful.

CR95HF_ERROR_CODE: Unsuccessful command, UART

communication may be lost.

AN3985 数据表(PDF) 21 Page - STMicroelectronics

AN3985 数据表(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载