AN4128

Getting started

Doc ID 023306 Rev 1

21/28

Figure 30.

Automatic connection dongle1, dongle2

●

Delete smart cable setup:

The command to remove the SmartCableSetup is:

–

AT+AB DeleteSmartCable

if the operation is successful, the answer is:

–

AT-AB DeleteSmartCableDone

To give the command the dongle must be in; -CommandMode-.

●

Erase bond table:

The erase bond table command must be used to clear all the bonded device entries:

–

AT+AB EraseBondTable

if the operation is successful, the answer is:

–

AT-AB BondTableErased

6.2.3

Command and answer syntax

The syntax of the commands is fixed and cannot be changed, the prefix for each command

is AT+AB.

Each command has an answer which is preceded by the prefix AT-AB; this identifier can be

changed by means of the AT+AB config command.

If it is necessary to change the prefix of the answer from AT-AB to “>>” on dongle1, the steps

to follow are shown in Figure 31: